Recent Posts

+421 (2) 20 283 002

LED Ethernet Controller Powered

LED Strip Studio > LED Ethernet Controller Powered

LED Ethernet Controller Powered

This device is produced as a powered advance controller for all types of LED (WS, TM or APA family). LEC Powered is able to control up to 4096 programmable RGB LEDs or 3072 RGBW LEDs, separately. Furthermore, it supports RJ-45 interface, because it makes no sense to use a ridiculous amount of DMX devices used for controlling the equal amount of LEDs.

Art-Net, DMX, LED Strip studio software are supported.

Tech Specs

The most important details about LED Ethernet Controller Powered you can find below. For more detailed description, please, contact us at

Maximum of RGB / RGBW programmable LEDs 4096 / 3072 pcs
SPI LEDs Outputs 4 pcs
Maximum of RGB / RGBW programmable LEDs per SPI Out 1024 / 768 pcs
Power 100 – 240 V 4.0 A
Dimensions 395 x 155 x 44 mm

As a matter of fact, you’re able to plug power cable with power 100 – 240 V. If you need to add another LED Controller or another device, just use the power output for 100 – 240 V.


Except most widely used connectors as DMX In/Out, RJ-45 (Artnet,  MMX In/ Out)Wireless DMX, SPI, Sd-Card for stand-alone mode and buttons for direct control of LED controller. You can also use power input and output connector, as a power source for another LED controller.

DMX In/Out

allows you to control LEDs via DMX.

MMX In/Out over RJ-45

allows you to control LEDs via MMX over RJ-45 connector.


allows you to send signal to LEDs.


allows you stand-alone mode.


allows you to control LEDs via ArtNET.

Power Con In/Out

allows you to use 100 - 240 V power source.


Our LED controllers let you work and control them as you wish. That’s the reason why we’re bringing you these 4 ways of controlling your LED devices, straightaway.


Use DMX standard for controlling your LEDs. LED Ethernet controller powered supports 3 pin DMX connector.

LED Strip Studio software

Many times you need to control complete system live. For these cases, please, use LED Strip Studio software.

More about LED Srtip Studio software

Wireless DMX

For more comfortable controlling your LEDs, please, use wireless DMX options. Let us know anything linked to this matter.


In case you need to control your LEDs direct from LEC SPI, you can use two buttons for that.

Stand-alone mode

This mode allows you to control LEDs over SD-card and you don’t need any kind of software to control it. Choose effects by using buttons or DMX signal.


Technical specification of LEC 3 Powered
User Manual and Tech. documentation
The lastest firmware of LEC 3 Powered